Waterway Executive "smooth body" pump

This Waterway Executive two-speed pump uses a smooth-body cylindrical motor made by US Motor. This motor was formerly branded A.O. Smith Century Lasar or GE Marathon Electric.

This version is longer, less tall and quite a bit more expensive than the of this pump, which uses an EMG motor. We recommend that use use the standard version instead of this one unless you need to replace your existing Century Lasar pump with a motor of the same type (one good reason to do this would be if you have very little space above the pump, for example).

Our technicians often use the US Motor version in situations where the EMG Type 90 motor is too high, for example.

Dimensions
Length: 330 mm
Width: 215 mm
Motor width: 150 mm
Height: 215 mm

Technical specifications
Power high speed: 2.05 kW (2,25 HP)
Power low speed: 0.67 kW
Current high speed: 8.9 A
Current low speed: 2,9 A

Connections
Discharge: Male threaded with an assymetric 2-inch MBT thread (outside diameter of 78 mm).
Suction: Male threaded with an assymetric 2-inch MBT thread (outside diameter of 78 mm ) or 2.5-inch MBT thread (outside diameter of 94 mm.
The Waterway Executive US Motor pump is normally connected to a 2-inch pipe.

Cable and plug
The Waterway Executive US Motor is is delivered without plug and cable. If you are replacing an existing pump, you may be able to re-use your existing power cord. There is a wiring diagram for connecting it up on the inside of the cover of the water-resistant electrical box.

You can also choose to have the pump pre-cabled by our team with an AMP plug or a mini J&J plug.

An in.link plug (100 cm long) is also available, but we recommend that you keep your existing cable if it's in good condition. Your pump may indeed be defective for many reasons, but the power cable is rarely to blame.

Spare parts
We have spare parts for the Waterway Executive "smooth body" pump

Warranty
2-year Tubs Parts warranty

Part numbers
Waterway: PF-25-2N22X,PP-25-2N22X, 3421451-10