Please select from the available options

HydroAir Slimline suction wall fitting

In stock
9,00€
incl. 20% VAT
Version
Quantity:  
HydroAir Slimline suction wall fitting - Click to enlarge
HydroAir Slimline suction wall fitting - Click to enlarge
HydroAir Slimline suction wall fitting - Click to enlarge
HydroAir Slimline suction wall fitting - Click to enlarge

This Balboa HydroAir wall fitting is part of the Slimline suction assembly. The suction grille screws directly into it, on the inside of the spa.

It is available in standard and long versions, depending on your installation. With its very thin flange, the long version works well on wooden spas. The standard version is suitable for spas with walls up to 20 mm thick.

The wall fitting can be screwed on using a straight adapter (1.5-inch or 50 mm), or an 90°-elbow adapter (1.5-inch or 50 mm).

The long version can also be fixed in place with a simple nut and glued directly to a 1.5-inch pipe.

Installation
You should install it with a gasket and also use silicone between the wall fitting and the interior wall of the spa.

Dimensions
Hole width to drill (external thread diameter) : 60 mm
Maximum wall thickness: about 20 mm for the standard version, 40 mm for the long version
External diameter of the face of the fitting: 85 mm
Inside diameter of the face of the fitting: 47 mm
Total length (short version): 34 mm
Total length (long version): 54 mm

Balboa HydroAir part numbers
Standard version: 30-6908, 10-6908
Long version: 30-6903, 10-6903